Emulex 110 Guia de Instalação descarregar pdf (Página 99)

Installing adapter driver and software utilities

Installation and Configuration

Installing adapter driver and software utilities

Emulex adapters must be installed in the server prior to installing the

drivers and utilities. (Refer to “Installing the adapter” on page 22.)

To use EMC storage array disks with a Windows 2000, 2003, or 2008

host, you need a Fibre Channel host adapter driver. The driver and

related utilities must be installed and configured before Windows can

access the EMC disks. This is done with ease during the Windows

setup (if booting from SAN) or by using the Emulex AutoPilot

Installer Kit. AutoPilot Installer helps you install and configure

drivers for your Emulex Fibre Channel adapters by walking you

through the following steps:

◆ Adapter selection

◆ Driver installation (SCSI or STOR)

◆ Utility installation

◆ Installation verification

Three sections are outlined on the following pages to help with

installation and configuration of your adapter drivers and utilities

using the AutoPilot Install Kit:

◆ “Pre-installation guidelines”, next

◆ “Installing or upgrading the driver and utilities” on page 100

Pre-installation guidelines

For Windows 2003, EMC supports both the STORPort driver class

and the SCSIPort driver class. EMC recommends STORport in most

cases. SCSIPort drivers for Windows 2003 have been frozen and no

new versions are planned for this model. Windows 2000 uses only the

SCSIPort driver class.

Note: Refer to the EMC Support Matrix for the latest required adapter

revisions.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 239 240

Sem comentários

Emulex 110 Guia de Instalação Página 99