
Installing Windows on an external SAN disk using an EFI RAMDISK
79
Installation and Configuration
Installing Windows on an external SAN disk using an EFI RAMDISK
This section provides procedures for installing Windows 2000/2003
and Windows 2008 operating systems.
◆ “Windows 2000/2003 external boot disk installation,” next
◆ “Windows 2008 internal/external boot disk installation” on
page 86
Windows 2000/2003 external boot disk installation
This section is a step-by-step procedure for installing Windows
2000/2003 operating system on an external boot device.
After you have your adapter(s) installed in your server and
configured for external boot the next step is to install the Windows
operating system. If you intend to boot to an external device, refer to
““Updating the flash firmware/BIOS” on page 30 and “Emulex
LightPulse-based Fibre Channel adapter BIOS/boot LUN settings”
on page 38 for setting the boot BIOS for external boot and selecting
the external boot LUN. If your system is EFI based, refer to the
section on creating an EFI RAMDISK: “Installing a RAMDISK under
the EFI shell” on page 78. Also refer to your server's documentation
for preparing your server for external boot.
Note: If you intend to boot to an external disk, present only the LUN from
which you intend to boot. All additional LUNs can be added after the
installation. This will eliminate confusion on selecting the correct partition
for installation and eliminates any problems that the operating system could
encounter on reboot during the installation. Also confirm there is only one
path to the storage array. Having more that one path can cause the operating
system to fail during the installation.
To install Windows, you need the following materials:
◆ A Windows CD-ROM for the Windows version you wish to
install.
◆ A USB drive with the files required for installation. Refer to
“Preparing the USB drive” on page 63 for more information.
◆ A floppy disk containing your EMC-approved adapter.
Comentários a estes Manuais