Emulex 110 Guia de Instalação descarregar pdf (Página 40)

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Installation and Configuration

Figure 12 Emulex LightPulse BIOS utility

In this example, only a single adapter is installed. If multiple

adapters are installed, there will be multiple adapter entries. The

order of the adapter instances listed is the order they will be

scanned for a boot device; note that this does not necessarily

correspond to PCI slot numbering.

2. Select the row number of the adapter instance that corresponds to

the adapter that will be used for boot and press Enter.

This displays a screen similar to Figure 13.

Figure 13 Adapter configuration selection

Note: For boot-from-SAN configurations, EMC recommends setting the

default BIOS settings before configuring boot settings. This will clear the

board of any settings that may be left over from a previous install if the

adapter was previously used in another system. Press <d> at the adapter

Configuration Selection screen to set the adapter default settings.

3. Type 2 (Configure This Adapter’s Parameters) and press Enter.

Various configuration options are presented, as shown in

Figure 14 on page 41.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 239 240

Sem comentários

Emulex 110 Guia de Instalação Página 40