Emulex 110 Guia de Instalação descarregar pdf (Página 218)

218

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Miscellaneous Planning and Procedures

Special instructions for CLARiiON CX200-Series

This section contains special instructions to set the adapter FC-AL

Loop ID for the CLARiiON CX200-Series.

Set the adapter FC-AL Loop ID

While configuring an Emulex LPx adapter for Windows and

connection to EMC CLARiiON CX200-Series for direct-connect

cluster configurations, you must manually set the adapter AL_PA

(FC-AL Loop ID). Once set, this value will be honored by the adapter

and driver throughout the boot process.

In the following steps, you do not need to enable the Boot BIOS or

change the default topology settings, since the adapter will not be

used as a boot device.

To manually set the AL_PA on each adapter:

Note: This procedure requires a minimum adapter BIOS revision of 1.60a7. If

you are not at this minimum revision, update to the latest supported adapter

BIOS revision as described under “Updating the flash firmware/BIOS” on

page 30.

Note: Perform this procedure on all nodes in the cluster connected to the

CX200-Series array.

Note: Future firmware upgrades will not overwrite changes made using this

procedure.

1. Reboot the server; when the Emulex BIOS banner (shown below)

appears, press Alt–E to start the BIOS utility:

If you miss the banner, reboot and try again.

!!! EMULEX LP8000 BIOS, Copyright xxxx !!! xB1.60A7

Press <Alt E> To Go To EMULEX BIOS Utility

Press <s> To Skip EMULEX BIOS

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 239 240

Sem comentários

Emulex 110 Guia de Instalação Página 218