Emulex 110 Guia de Instalação descarregar pdf (Página 140)

140

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Installation and Configuration

◆ Before you can perform a firmware update, the firmware file

must be downloaded from the Emulex website and extracted to a

folder on a local drive. This file could be included on

EMC-approved installation media, or downloaded from the

Emulex website, as described in “Downloading latest Emulex

drivers/firmware/BIOS files” on page 20.

◆ If the adapter is already connected to a boot device, the system

must be in a state in which this type of maintenance can be

performed:

• I/O activity on the bus has been stopped.

• Cluster software, or any other software that relies on the

adapter to be available, is stopped or paused.

Updating firmware for a single adapter

To update the Fibre Channel firmware on your FCoE converged

network adapter, complete the following steps.

Note: The procedures in this section require that the adapter driver and the

OneCommand Manager utility be installed first.

1. Start the OneCommand Manager utility, as shown in Figure 116.

In the left pane of the utility, you will see the CNA listed under

your server name.

Figure 116 OneCommand Manager window

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 239 240

Sem comentários

Emulex 110 Guia de Instalação Página 140