Emulex LP1005DC-CM2 Manual do Utilizador descarregar pdf (Página 73)

Driver for Linux - Configuration Section Page 67

3. Click a target in the discovery tree.

4. Click on the Target Mapping tab.

Figure 30: The HBAnyware Target Mapping Tab

Set Up Persistent Binding

When you create a persistent binding, HBAnyware tries to make that binding dynamic. However, the

binding must meet all of the following criteria to be dynamic:

• The SCSI ID (target/bus combination) specified in the binding request must not be mapped to

another target. For example, the SCSI ID must not already appear in the 'Current Mappings'

table under 'SCSI ID'. If the SCSI ID is already in use, then the binding cannot be made

dynamic, and a reboot is required.

• The target (WWPN, WWNN or DID) specified in the binding request must not be mapped to a

SCSI ID. If the desired target is already mapped, then a reboot is required.

• The 'Bind Type Selection' (WWPN, WWNN or DID) specified in the binding request must match

the currently active bind type shown under “Current Settings” section of the Target Mapping

tab. If they do not match, then the binding cannot be made active.

To set up persistent binding:

1. Start HBAnyware.

2. In the directory tree, click the host bus adapter (HBA) for which you want to set up persistent

binding.

3. Click the Target Mapping tab. All targets are displayed.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 161 162

Sem comentários

Emulex LP1005DC-CM2 Manual do Utilizador Página 73