Emulex LP1005DC-CM2 Manual do Utilizador descarregar pdf (Página 10)

Driver for Linux - Installation Section Page 4

Once the 'lpfc-install' script has completed successfully, the Emulex lpfc and lpfcdfc drivers are

loaded, and Fibre Channel disks that are properly connected to the system are accessible.

Reboot the system now to enable the newly added driver options in the ramdisk. You can also

reboot the system later if you wish.

Driver Kit Install Script Options

The following options are available for use with the Emulex install script for Linux:

• -c,--configfile - Specify lpfc.conf file to use during installation.

• --configramdisk - Configure and build a ramdisk image that loads the Emulex driver when the

system is booted with the current kernel.

• --createramdisk - Create a new ramdisk image. Use this option after you have modified driver

parameters in the lpfc.conf file and rebuilt the driver.

• -h,--help - Prints a help message describing command line parameters.

• -u,--uninstall - Uninstall previously installed driver kit.

• --unconfigramdisk - Configure and build a ramdisk image that does not load the Emulex driver

when the system is booted with the current kernel.

Directory Structure

After installation, the following directories are created on the system.

Table 1: Directory Structure

Directory Description

/usr/sbin/lpfc Driver utilities (This directory is created after the

utilities are installed.)

/usr/src/lpfc Driver source files

/usr/sbin/hbanyware HBAnyware files (This directory is created after the

utilities are installed.)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 161 162

Sem comentários

Emulex LP1005DC-CM2 Manual do Utilizador Página 10