Emulex LP1005DC-CM2 Manual do Utilizador descarregar pdf (Página 61)

Driver for Linux - Configuration Section Page 55

Configure the Driver

You can configure the driver using HBAnyware or lpfc.conf.

Configure Driver Parameters Using HBAnyware

The Driver Parameters tab allows you to modify driver parameters either for an individual adapter or for

all adapters, with the same single driver type and version, that are in one host.

For example, if you set driver parameters on a host that includes two adapters with the lpfc driver

installed, you can make changes to the driver parameters for both adapters simultaneously.

For each parameter, the tab displays the current value, the range of acceptable values, the default

value, and whether the parameter is dynamic (a dynamic parameter allows the change to take effect

without recompiling and reloading the driver).

This topic includes the following procedures:

• View Driver Parameters for an Adapter

• View Driver Parameters for a Host

• Change a Parameter's Value

• Restore Parameters to Their Earlier Values

• Reset All Default Values

View Driver Parameters for an HBA

To display the driver parameters for an adapter:

1. Start HBAnyware.

2. Do one of the following:

• From the menu bar, click View, then click Group HBAs by Host Name.

• From the toolbar, click the Group HBAs by Host Name button.

3. In the discovery tree, click the adapter for which you want to change a parameter. The General

tab is displayed.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 161 162

Sem comentários

Emulex LP1005DC-CM2 Manual do Utilizador Página 61