Emulex LP1005DC-CM2 Manual do Utilizador descarregar pdf (Página 20)

Driver for Linux - Configuration Section Page 14

Configuration

Introduction

The Emulex driver for Linux has many options that can be modified to provide for different behavior. You

can change these options using the HBAnyware™ utility or the LightPulse® lputil utility.

• The HBAnyware utility is a Java-based, user friendly graphical environment. Use HBAnyware to

do any of the following:

• Discover HBAs

• Reset HBAs

•Sort HBAs

• Set up persistent binding

• Set driver parameters

• Update firmware on the local HBA or on remote HBAs

• Load EFIBoot

• The LightPulse utility (lputil) is a command-line interface. Use lputil to do any of the following:

• Download PCI configuration data files

• Discover HBAs

• Reset HBAs

• Update firmware on the local HBA

• Update x86 BootBIOS

• Enable the x86 BootBIOS message

• Load EFIBoot

Start HBAnyware for Linux

To start HBAnyware for Linux:

1. su to ‘root’.

2. Run the script:

/usr/sbin/hbanyware/hbanyware

To start the HBAnyware Security Configurator for Linux:

1. su to ‘root’.

2. Run the script:

/usr/sbin/hbanyware/ssc

Note: HBAnyware's rmserver must be running on all remote hosts that are to be discovered

and managed.

Remote capabilities of HBAnyware are subject to fabric zoning configuration. Remote

hosts to be discovered and managed by HBAnyware must be in the same zone.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 161 162

Sem comentários

Emulex LP1005DC-CM2 Manual do Utilizador Página 20