Emulex LP10000ExDC Manual do Utilizador descarregar pdf (Página 31)

100

101

Load the Driver

Before attempting to load the driver you can test the driver.

To test the driver type:

# insmod lpfcdd

# insmod lpfndd

❍ lpfcdd - main driver, SCSI functionality, FCP support, diagnostic support

❍ lpfndd - IP support (this driver is dependent on lpfcdd being loaded first)

Note

If the system does not have a SCSI driver loaded or built

into the kernel, enter the following before loading lpfcdd:

# insmod scsi_mod

# insmod sd_mod

Load the driver through the RAM disk image

To load the driver:

1. To add SCSI and IP modules, edit /etc/modules.conf.

2. Add the following line to add a SCSI module:

alias scsi_hostadapter lpfcdd

3. Add the following line to add an IP module:

alias lpfnX lpfndd

where X is the interface number, 0 through 31.

Note

If you want to configure SCSI only, just add the

scsi_hostadapter line. The IP module is dependent on the

SCSI modules being there, so you cannot configure just IP.

4. Run the following command to update your system with the information you added to /etc/modules.

conf:

# depmod -a

5. For IP support, edit /etc/sysconfig/network-scripts/ifcfg-lpfnX. Where X is the interface number, 0

through 7. This file should be created if you wish to configure IP.

Emulex Documentation, Drivers and Software

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 365 366

Comentários a estes Manuais

Sem comentários

Emulex LP10000ExDC Manual do Utilizador Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Software Emulex LP10000ExDC