Emulex LP10000ExDC Manual do Utilizador descarregar pdf (Página 106)

Set Driver Parameters Using HBAnyware

The Driver Parameters tab allows you to modify driver parameters either for an individual

adapter or for all adapters, with the same single driver type and version, that are in one

host.

For example, if you set driver parameters on a host that includes two adapters with the

SCSIport Miniport driver installed, you can make changes to the driver parameters for both

adapters simultaneously.

For each parameter, the tab displays the current value, the range of acceptable values, the

default value, and whether the parameter is dynamic (a dynamic parameter allows the

change to take effect without restarting the HBA or rebooting the system).

This page contains instructions for the following:

● View Driver Parameters for an Adapter

● View Driver Parameters for a Host

● Change a Parameter's Value

● Restore Parameters to Their Earlier Values

● Reset All Default Values

View Driver Parameters for an Adapter

To display the driver parameters for an adapter, do the following:

1. Start HBAnyware.

2. Do one of the following:

❍ From the menu bar, click View, then click Sort by Host Name.

❍ From the toolbar, click the button.

3. In the discovery tree, click the adapter for which you want to change a parameter.

The General tab is displayed.

4. Click the Driver Parameters tab. The Installed Driver Types field displays the driver

that is installed on the adapter.

Emulex Documentation, Drivers and Software

106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 365 366

Sem comentários

Emulex LP10000ExDC Manual do Utilizador Página 106