Emulex LP9802DC Manual do Utilizador descarregar pdf (Página 26)

Driver for HP-UX - Troubleshooting Section Page 23

lpfcN: 11: Unknown Identifier in RSCN payload

DESCRIPTION: Typically the identifier in the RSCN payload specifies a domain, area or a specific

N_Port ID. If neither of these are specified, a warning will be recorded. The value of the illegal identifier

will be recorded.

LOG: WARNING always fcelsb.c

ACTION: Potential problem with Fabric. Check with Fabric vendor.

lpfcN: 12: ELS Retry failed

DESCRIPTION: If an ELS command fails, it may be retried up to 3 times. This message will be recorded

if the driver gives up retrying a specific ELS command. The value of the ELS command and the Remote

PortID will be recorded.

LOG: WARNING ELS verbose fcelsb.c

ACTION: If the ELS command is a PRLI, and the destination PortID is not an FCP Target, no action is

needed. Otherwise, check physical connections to Fibre Channel network and the state the remote

PortID is in.

lpfcN: 13: Service Level Interface selected

DESCRIPTION: Either a CONFIG_PORT (SLI2) or PART_SLIM (SLI1) mailbox command was issued.

The SLI selected, 1 or 2, and the virtual address of the SLIM will be recorded.

LOG: WARNING MISC verbose fcmboxb.c

ACTION: none needed.

lpfcN: 14: Memory Buffer Pool is below low water mark

DESCRIPTION: A driver memory buffer pool is low on buffers. The buffer pool number and low water

mark are recorded.

ACTION: none needed.

LOG: WARNING MISC verbose fcmemb.c

lpfcN: 15: Memory Buffer Pool is out of buffers

DESCRIPTION: A driver memory buffer pool is exhausted. The buffer pool number is recorded.

LOG: ERROR always fcmemb.c

ACTION: Configure more resources for that buffer pool. If problems persist report these errors to

Technical Support.

lpfcN: 16: Cannot find virtual address for mapped buffer

DESCRIPTION: The driver cannot find the specified buffer in its mapping table. Thus is cannot find the

virtual address needed to access the data. The mapped buffer address and ring number are recorded.

LOG: ERROR always fcmemb.c

ACTION: If problems persist report these errors to Technical Support.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 34 35

Sem comentários

Emulex LP9802DC Manual do Utilizador Página 26