Emulex LightPulse LPe12000 Manual de Instalação

LPe12000 and LPe12002 HBAInstallation ManualLast updated January 29, 2008

LPe12000 and LPe12002 Hardware Installation Manual Page 74 Fast Blinks On 8Gb Link rate-Normal, link up Off Slow Blink Normal-link down or not starte

LPe12000 and LPe12002 Hardware Installation Manual Page 8ReferencesSpecificationsTable 9. LPe12000 and LPe12002 SpecificationsParameter RangeMedia In

LPe12000 and LPe12002 Hardware Installation Manual Page 9FCC and Regulatory NoticesLPe12000 and LPe12002 HBA ModelsThis device complies with Part 15

LPe12000 and LPe12002 Hardware Installation Manual Page 10Notice for Taiwan and Translations (BSMI)Translation:This equipment is a Class A ITE, and o

LPe12000 and LPe12002 Hardware Installation Manual Page 11

LPe12000 and LPe12002 Hardware Installation Manual Page 12Laser Safety NoticeThis laser safety information contains certification and product informa

LPe12000 and LPe12002 Hardware Installation Manual Page 13Alternatively, at the discretion of the manufacturer, the same statement may be included in

LPe12000 and LPe12002 Hardware Installation Manual Page 14factor transceiver, and the system level documentation and labeling. Copies of the certific

LPe12000 and LPe12002 Hardware Installation Manual Page ii Copyright© 2008 Emulex Corporation. All rights reserved worldwide. No part of this document

LPe12000 and LPe12002 Hardware Installation Manual Page iiiTable of Contents Introduction...

LPe12000 and LPe12002 Hardware Installation Manual Page 1IntroductionThis manual describes the Emulex® LPe12000 and LPe12002, 8 gigabit per second (G

LPe12000 and LPe12002 Hardware Installation Manual Page 2Setting the JumpersThe device ID jumpers are used in custom applications. Do not change the

LPe12000 and LPe12002 Hardware Installation Manual Page 3Installing the Host Bus AdapterThe Emulex LPe12000 and LPe12002 host bus adapters (HBAs) use

LPe12000 and LPe12002 Hardware Installation Manual Page 4Figure 3 shows one transceiver partly extracted and the other latched in placeFigure 3: Remo

LPe12000 and LPe12002 Hardware Installation Manual Page 5Attaching MediaUse multimode fiber optic cable, with short-wave lasers, that adheres to the

LPe12000 and LPe12002 Hardware Installation Manual Page 6Applying PowerTo apply power:1. Verify that the HBA is securely installed in the computer.2.