Emulex LP9802DC Manual do Utilizador descarregar pdf (Página 40)

Loading Boot Code

If you are using the HP-UX 11.11 operating system with an Emulex LP9802DC,

LP9402DC or LP8000DC host bus adapter, you must load the boot code before updating

the firmware.

Prerequisites:

● The driver for HP-UX is installed properly.

● You have at least one dual channel adapter.

● The boot code file has been downloaded to a local drive.

This procedure uses the lputil utility, which is installed with the driver.

Caution

Failure to load the boot code will make a dual channel

adapter unavailable after a system reboot.

Procedure

1. Start the utility by entering the complete path to lputil. The path in the example

reflects the default installation path. If the installation path was modified, adjust the

command appropriately.

/opt/lpfc/bin/lputil

2. From the Main menu, enter 3, Firmware Maintenance.

3. Enter 1, Load Firmware Image.

4. Enter the full path to the boot code file.

The new boot code is transferred to flash ROM.

Emulex Documentation, Drivers, and Software

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 68 69

Sem comentários

Emulex LP9802DC Manual do Utilizador Página 40