Emulex LP9802DC Manual do Utilizador descarregar pdf (Página 32)

digit representation of the target's WWPN or WWNN.

Xis the driver instance number

Yis the target assignment.

Line 15 provides a sample.

Multiple entries must be separated by a comma, with the last entry terminated with 0 as shown

on line 19.

9. Enter LUNs to be blocked in curly brackets separated by commas (see line 16).

NUMBER:lpfcXtY{#,#,#,#,

where NUMBER:lpfcXtYsets the binding

#are the LUNs to be blocked.

Line 16 provides a sample.

10. Summarize the adapter configuration (this is required). Locate the following section in the

adapCfg.h file.

11. Replace the variable # with the adapter instance number.

12. If changes were made to the adapter configuration parameters, line 25 should be changed from

0 to lpfcOver_#, as shown in line 25. This is to set the Per-Adapter Configuration Structure.

13. If persistent bindings were set up, lines 26, 27 or 28 reflect the change depending on whether

the bindings were made based on the WWNN (line 26), WWPN (line 27) or D_ID (line 28). The

above sample shows a binding that was made using the D_ID of the target.

14. Follow steps 5 through 10 of the

Change Configuration Parameters

procedure. These

necessary steps include setting the per-adapter configuration structure, summarizing adapter

information, saving the adapCfg.h file, rebuilding the kernel, rebooting the system and

running

ioscan.

Emulex Documentation, Drivers, and Software

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 68 69

Sem comentários

Emulex LP9802DC Manual do Utilizador Página 32