Emulex LP9802DC Manual do Utilizador descarregar pdf (Página 19)

RSCNDELAY

Minimum value = 0, maximum value = 60 (decimal). Default = 0;

RSCNDELAY specifies the time, in seconds, to delay a query to the Fibre Channel

Name Server after a State Change Notification. The default value should be

satisfactory for most cases.

RSCNZONE

Boolean parameter: 0 = not selected, 1 = selected. Default is RSCNZONE=1;

If set to 1 (default), always query the Fibre Channel Name Server after a State Change

Notification. If set to 0, query only when necessary.

SCANDOWN

Boolean parameter: 0 assigns to each device in the loop a fixed SCSI ID in the range of

0 to 125. 1 assigns to each device in the loop a fixed SCSI ID in the range of 125 to 0.

This parameter applies ONLY to private loop configurations.

Scan Direction for Loop Auto Binding:

When SCANDOWN=0, this option assigns to each device in the loop a fixed

SCSI ID in the range 0 to 125, in increasing order depending on the AL_PA of

the device. For instance, the device at AL_PA 1 will always have the SCSI ID

x01, and the device at AL_PA xEF will always have the SCSI ID 125. This is

the default, and matches the behavior of earlier drivers.

When SCANDOWN=1, this option assigns to each device in the loop a fixed

SCSI ID in the range 125 to 0 , in decreasing order depending on the AL_PA of

the device. For instance, the device at AL_PA xEF will always have the SCSI

ID 0, and the device at AL_PA x01 will always have the SCSI ID 125.

Emulex Drivers, Software and Manuals

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

Emulex LP9802DC Manual do Utilizador Página 19