
102
EMC Host Connectivity with Emulex FC HBAs and FCoE CNAs for the Linux Environment
Updating the Adapter and CEE/Menlo Firmware
Updating Emulex CEE /Menlo firmware for LP21000-E/LP21002-E
FCoE adapters
Each Emulex Fibre Channel controller has a flash upgradable
firmware and boot BIOS. In most instances, it is necessary to keep
only the firmware up-to-date, because the BIOS is applied only when
using connected storage as a boot device. The latest supported
firmware can be found on the Emulex website:
http://www.emulex.com/ts/docoem/framemc.htm
From this site, select the appropriate file for your adapter. The files
are typically in a
.zip file that contains different combinations of
firmware and BIOS images. Extract the downloaded file to a diskette,
and refer to
readme.txt to determine which filename image to use.
If you are upgrading the firmware and BIOS, you must upgrade the
firmware first, because it might contain an older BIOS version,
which you can update separately later.
FCoE adapters include an additional chip component which requires
the latest supported firmware. This chip is commonly referred to as a
CEE (converged enhanced ethernet) or "Menlo" chip, the purpose of
which is to handle the convergence of storage (FC) and network (IP)
traffic over a single ethernet interface.
Note: To update the boot BIOS, refer to Chapter 3, ”Installing and
Configuring the BIOS Settings.”
To update the CEE/Menlo firmware on the CNAs, follow these steps:
1. Copy the appropriate CEE/Menlo firmware file from the
CD-ROM or the EMC-approved section of the Emulex website to
the appropriate directory, /usr/sbin/hbanyware.
2. Execute the command /usr/sbin/hbanyware/hbacmd ListHBA,
and record the "Port WWN" information for all adapters within
the host.
3. Execute the command /usr/sbin/hbanyware/hbacmd
CEEdownload <WWPN> <CEEfirmwarefile>, where WWPN is
the first Port WWN recorded from Step 2, and CEEfirmwarefile is
Comentários a estes Manuais